Signal | E1 | E6X | E8X |
---|---|---|---|
GND | black | 1 | 1 |
+UB | brown | 2 | 2 |
A | red | 3 | 3 |
B | orange | 4 | 4 |
I, R | blue | 5 | 5 |
nc | 6 | 6 | |
nc | 7 | 7 | |
nc | 8 | ||
nc | 9 |
Headquarters: SIKO GmbH Weihermattenweg 2 79256 Buchenbach Germany Phone+49 7661 394-0 [email protected]
Reading distance ≤1 mm
Feature | Technical data | Additional information |
---|---|---|
Housing | green plastic | |
Sensor/band reading distance | 0.1 … 1 mm | O, I reference signals |
0.1 … 0.4 mm | R reference signal | |
Sensor/ring reading distance | 0.1 … 0.8 mm | O, I reference signals |
0.1 … 0.4 mm | R reference signal | |
Cable sheath | PUR suitable for drag-chain use | 4-wire ø4.4-0.4 mm; 5, 6, 8-wire ø5-0.4 mm |
Cable bending radius | 5x cable diameter | static |
7.5x cable diameter | dynamic | |
Service life of cable | >5 million cycles | under the following test conditions: travel range 4.5 m travel speed 3 m/s acceleration 5 m/s2 ambient temperature 20 °C ±5 °C |
Feature | Technical data | Additional information |
---|---|---|
Operating voltage | 24 V DC ±20 % | reverse polarity protected |
5 V DC ±5 % | no reverse polarity protection | |
Current consumption | <20 mA | at 24 V DC, off-load |
<75 mA | loaded | |
Output circuit | PP, LD (RS422), TTL | PP only with 24 V |
Output signals | A, A/, B, B/, I, I/, R, R/ | quadrature signal |
Output signal level high | >UB - 2.5 V | PP |
>2.5 V | LD | |
>2.4 V | TTL | |
Output signal level low | <0.8 V | PP |
<0.5 V | LD | |
<0.4 V | TTL | |
Latency | 1.5 µs | |
Jitter | <15 % | 0.5 mm reading distance |
Pulse width of reference signal | 1 increment(s) | |
Real-time requirement | speed-proportional signal output | |
Type of connection | open cable end | |
plug connector | 7/8-pole | |
D-Sub | 9-pole |
Feature | Technical data | Additional information |
---|---|---|
Resolution | 0.025, 0.05, 0.1, 0.5 mm | |
Scaling factor | 1, 5, 10, 20 | |
System accuracy | ±(0.05 + 0.01 x L) mm, L in m | at TU = 20 °C |
±0.1° | at TU = 20 °C | |
Repeat accuracy | ±1 increment(s) | |
Measuring range | ∞ | |
Circumferential speed | ≤25 m/s | ≤2 m/s referencing speed |
Travel speed | ≤25 m/s | ≤2 m/s referencing speed |
Feature | Technical data | Additional information |
---|---|---|
Ambient temperature | -10 … 70 °C | |
Storage temperature | -30 … 80 °C | |
Relative humidity | 100 % | condensation admissible |
EMC | EN 61000-6-2 | interference resistance / immission |
EN 61000-6-4 | emitted interference / emission | |
Protection category | IP67 | EN 60529 |
Shock resistance | 500 m/s2, 11 ms | EN 60068-2-27 |
Vibration resistance | 100 m/s2, 5 … 150 Hz | EN 60068-2-6 |
Signal | E1 | E6X | E8X |
---|---|---|---|
GND | black | 1 | 1 |
+UB | brown | 2 | 2 |
A | red | 3 | 3 |
B | orange | 4 | 4 |
I, R | blue | 5 | 5 |
nc | 6 | 6 | |
nc | 7 | 7 | |
nc | 8 | ||
nc | 9 |
Signal | E1 | E6X | E8X |
---|---|---|---|
A | red | 1 | 1 |
B | orange | 2 | 2 |
nc | 3 | 3 | |
+UB | brown | 4 | 4 |
GND | black | 5 | 5 |
A/ | yellow | 6 | 6 |
B/ | green | 7 | 7 |
nc | 8 | ||
nc | 9 |
Signal | E1 | E6X | E8X |
---|---|---|---|
A | red | 1 | 1 |
B | orange | 2 | 2 |
I, R | blue | 3 | 3 |
+UB | brown | 4 | 4 |
GND | black | 5 | 5 |
A/ | yellow | 6 | 6 |
B/ | green | 7 | 7 |
I/, R/ | violet | 8 | 8 |
nc | 9 |
For systems with reference points on the magnetic tape please take care that sensor and tape are correctly aligned (see picture).
Reference signal | O, I linear | O, I radial | R |
---|---|---|---|
A, Sensor/tape reading distance | ≤1 mm | ≤0.8 mm | ≤0.4 mm |
B, Lateral offset | ±2 mm | ±2 mm | ±0.5 mm |
C, Alignment error | ±1° | ±1° | ±1° |
D, Longitudinal inclination | ±1° | ±1° | ±1° |
E, Lateral inclination | ±3° | ±3° | ±3° |
Feature | Order data | Specifications | Additional information |
---|---|---|---|
Operating voltage | A4 | 24 V DC ±20% | |
5 | 5 V DC ±5% | A voltage drop is to be expected with increasing cable length. This must be taken into account in the electrical design. | |
Type of connection | BE1 | open cable end | |
E6X | bullet connector without mating connector | ||
E8X | D-SUB 9-pole without mating connector | ||
cable extensions on request | |||
Cable length | C... | 1 ... 20 m, in steps of 1 m | |
others on request | |||
Output circuit | DPP | push-pull | only with operating voltage 4 |
LD | LineDriver | ||
TTL | TTL | only with non-inverted output signal, cable length ≤5 m | |
Output signal | ENI | not inverted | |
I | inverted | ||
Reference signal | FO | without | |
I | periodic index | index signal every 2 mm | |
R | fixed reference | ||
Linear resolution/ radial scaling factor | G... | 0.025/20, 0.05/10, 0.1/5, 0.5/1 | |
others on request | |||